Trouble with Ravager Assembly

The problem seems to be the piece that replaces the raider plank (it holds the bottom hole for the side guns). I just cant seem to get the raider sides to fit nicely with this piece in. Good job i was dry fitting first. Anyone else had this problem?

I have. On my first Ravager, I cleaned and sanded the edges but it still woulnd't fit, so I just trimmed some plastic with my trusty Xacto knife until it did. On my second Ravager, I played around with it more, and it seemed to snap onto the two guide holes at an odd height, but it let the two hull pieces fit together. Looking at the finished pieces now, it still doesn't seem to the intended position, as there is a little part of the hull that looks like it wants to be covered up and a flush edge made. You can't tell on the tabletop, though!

CaptainBalroga wrote:

I have. On my first Ravager, I cleaned and sanded the edges but it still woulnd't fit, so I just trimmed some plastic with my trusty Xacto knife until it did. On my second Ravager, I played around with it more, and it seemed to snap onto the two guide holes at an odd height, but it let the two hull pieces fit together. Looking at the finished pieces now, it still doesn't seem to the intended position, as there is a little part of the hull that looks like it wants to be covered up and a flush edge made. You can't tell on the tabletop, though!

I had the same problem, found the same solution to work.

Thanks, i trimmed the pieces a little (im building 2). One of them fits now, but the other i cant find whats going on with it.... oh well. Not perfect, but good enough =)